Agricultural Engineering, Volume 49 (2017)

RESEARCH OF STRENGTHENED PLOUGH POINT BY PLASMA TRANFERRED ARC WELDING

Egidijus Katinas, Vytenis Jankauskas, Povilas Kairys, Rimtautas Leišys
Aleksandras Stulginskis University; UAB "Dangų inžinerijos centras"

Abstract

Experiment based on strengthened plough point which produced from boron micro-alloyed steel. Cutting edge and front surface of plough point covered by plasma transferred arc welding (PTAW). This welding method creates relatively low thermal treatment of plough point steel and welded layer content has high tungsten carbide concentration which creates high wear resistance of working surface and cutting edge. This strengthening process increased working time of plough parts.

Keyword(s): plough point, plasma transferred arc welding, wear


References

V.Jankauskas, R.Kreivaitis, D.Stonkus, A.Andriušis. Research of strengthening plough parts by welding. Mechanika. 2008, Nr. 1(69), p. 80–84.

V.Jankauskas, E.Katinas, R.Skirkus, V.Aleknevičienė. The method of hardening soil rippers by surfacing and technical-economic assessment. Journal of Friction and Wear. Т. 35, N4 (2014), p. 270–277.

R.Choteborsky, M.Linda, M.Hromasova. Wear and stress analysis of chisel. Agronomy Research 15 (1), 2017, p. 971–980.

D.Bartkowski, A.Bartkowska. Wear resistance in the soil of Stellite-6/WC coatings produced using laser cladding method. Int. Journal of Refractory Metals and Hard Materials 64 (2017) 20–26.

T.Stawicki, B.Bialobrzeska, P.Kostencki. Tribological properties of plough shares made of pearlitic and martensitic steels. Metals 7(4), 2017, p. 139


Full Text: PDF

Refbacks

  • There are currently no refbacks.
1863 views

Agricultural Engineering ISSN 1392-1134 / eISSN 2345-0371

This journal is published under the terms of the Creative Commons Attribution-Noncommercial 3.0 Unported License. Responsible editor: Dr A. Žunda.