Agricultural Engineering, Volume 49 (2017)

INVESTIGATION OF ABRASIVE WEAR RESISTANCE OF ELECTROSPARK DEPOSITED (ESD) COATINGS FOR DRUM MOWER BLADES

Egidijus Katinas, Artūras Laskauskas
Institute of Power and Transport Machinery Engineering, Aleksandras Stulginskis University

Abstract

Electrospark deposition method creates thin coatings with high hardness. This property of coating is very useful for abrasive wear resistant material. For our research the coatings produced with the help of three different electrodes were used for laboratory and field tests. Laboratory test was made by ASTM G65-94 standard method. Field tests were performed with drum mower. For these test we covered mower blades in the same electrodes and conditions as laboratory test. During field test it was found that blades covered only on back side has lower wear than covered only on front side. Also it was found that blades covered on back side has sharper cutting edge.

Keyword(s): electrospark deposition, abrasive wear, drum mower


References

V.V.Michailov, A.E.Gitlevich, A.D.Verchotunov, A.I.Michailiuk, A.V.Beljakovs, L.A.Konevcov. Electrospark alloying of titanium and its alloys, physical and technological aspects and the possibility of practical use. Part I. Peculiarities of mass transfer, structural and phase transformations in surface layers, their wear and heat resistance. Chishinau, 2013. 21-42 p. doi: 621.9.048.4.

Drum mower “Mewa 1,65” user manual, 2006 (in Polish).

Chelpuri R. 2016. Some studies on wear characteristics of rotavator blades. Master thesis, Swami Vivekananda College of Agricultural Engineering and Technology.


Full Text: PDF

Refbacks

  • There are currently no refbacks.
2106 views

Agricultural Engineering ISSN 1392-1134 / eISSN 2345-0371

This journal is published under the terms of the Creative Commons Attribution-Noncommercial 3.0 Unported License. Responsible editor: Dr A. Žunda.